Ligh Switch base on Samplight Z-Stack Home 1.2.2a for CC2530, 2538 SOC

I use this board as light switch/high load switch, for a long distant normal one could not reach and I can choose any high current relay and contactor for very high load.

The module include an external antena can reach 200m distant: Z-0001 by WEBEE.

Where to buy:

• Include 2 module, kit and programing/debug tool: Kit
• Only the module: Module

Setup the relay/Contactor, and button:

• Connect relay control pin with P1.0.
• Connect your button with P0.0

Prebuild hex:

Ready to flash with your tool download it here: dnckatsw001.hex

Support gateway/hub:

Please check: Zigbee2Mqtt

Build it from scratch:

Step 1:

Download Z-Stack Home 1.2.2a it is free but require to register Z-Stack Home

Step 2:

Edit file C:\Texas Instruments\Z-Stack Home 1.2.2a.44539\Projects\zstack\HomeAutomation\SampleLight\Source\zcl_samplelight_data.c with those infor:

const uint8 zclSampleLight_ManufacturerName[] = { 6, 'D','N','C','K','A','T' };
const uint8 zclSampleLight_ModelId[] = { 11, 'D','N','C','K','A','T','_','S','0','0','1' };
const uint8 zclSampleLight_DateCode[] = { 16, '2','0','1','8','0','6','2','3',' ',' ',' ',' ',' ',' ',' ',' ' };

Step 3:

Add report state code to zclSampleLight_LcdDisplayUpdate:

  //report state
  zclSampleLightSeqNumState++;
  zclReportCmd_t rptcmd;
  rptcmd.numAttr = 1;
  rptcmd.attrList[0].attrID = ATTRID_ON_OFF;
  rptcmd.attrList[0].dataType = ZCL_DATATYPE_BOOLEAN;
  rptcmd.attrList[0].attrData = (void *)(&zclSampleLight_OnOff);

  // Set destination address to indirect
  zclSampleLight_DstAddr.addrMode = (afAddrMode_t)Addr16Bit;
  zclSampleLight_DstAddr.addr.shortAddr = 0;
  zclSampleLight_DstAddr.endPoint=1;
  zcl_SendReportCmd(SAMPLELIGHT_ENDPOINT,&zclSampleLight_DstAddr, ZCL_CLUSTER_ID_GEN_ON_OFF, &rptcmd, ZCL_FRAME_SERVER_CLIENT_DIR, true, zclSampleLightSeqNumState );

Step 4:

Disable ZCL_EZMODE and HOLD_AUTO_START build tag by add ‘x’ before each, and finally build and download to your module